How to Replace a Caliper in a Honda Prelude

The brakes in your Honda Prelude are among the most important parts of the vehicle. If something like the calipers must be replaced, it shou...

The brakes in your Honda Prelude are among the most important parts of the vehicle. If something like the calipers must be replaced, it should be in the hands of an expert. Talk with your mechanic before attempting to change any major part on your Prelude.

Instructions

Removal

    1

    Siphon about half the brake fluid out of the master cylinder reservoir. Don't allow the reservoir to empty to prevent as little air as possible to enter the system.

    2

    Raise and support the vehicle safely on the jack stand. Remove the tire and wheel assembly.

    3

    Unfasten the caliper's mounting bolts. Remove the caliper assembly from the rotor/bracket, pivoting it upward and sliding it off the pin.

    4

    Disconnect the brake hose from the caliper and plug the hose to prevent losing or contaminating the fluid. Don't let the caliper hang from the hose while doing this.

    5

    Remove the bolts on the caliper mounting bracket and remove the bracket from the rotor.

Installation

    6

    See that the new caliper's piston is completely bottomed in the bore. Retract the piston into the caliper with a C-clamp if necessary.

    7

    Clean the both steering knuckle abutments/support brackets. Run a mist of water over them and wipe with a damp towel. Lubricate them with a coating of multi-purpose grease.

    8

    Reinstall the caliper bracket and secure the mounting bolts. Position the caliper and brake pad assembly over the brake rotor.

    9

    Install the assembly into the steering knuckle or support bracket abutments. Make sure that the guide pin bolts, rubber bushings and sleeves are clear of the steering knuckle bosses.

    10

    Reconnect the brake hose, using new washers with the bolt. Fill the master cylinder with fresh fluid and bleed the brake system.

    11

    Attach the wheel and tire assembly back on. Lower the vehicle and tighten the lug nuts.

    12

    Press the brake pedal in two inch strokes, about three to four times, until the brake linings are seated and firm. Don't road test the vehicle until the brakes feel firm.

Hot in Week

Popular

Archive

item