How to Replace the Rotor in a Dodge Durango

If your Dodge Durango shudders and vibrates when you hit the brakes, it's probably time to replace the rotors. Rotors don't need to be replaced very often over the lifetime of your vehicle, but if they get worn down or become warped then they definitely need to be swapped out. The process is the same across all model years and you can do it in your own garage.

Instructions

1

Buy rotors for your Dodge Durango at your local auto parts store. Replace all of the rotors at once, or at least replace the front or rear pair at the same time for safe braking performance.

2

Jack up your Durango using jacks and jack stands and block the wheels to prevent them from rolling while you work. Remove the tire and wheel assembly with a socket wrench or an air ratchet.

3

Remove the caliper and mounting bolts and suspend these with mechanic's wire being careful not to disconnect the brake line. Never let the caliper hang from the brake line as this could damage the line or cause a disconnection followed by a big mess.

4

Unscrew the retainers on the wheel studs and then remove the old rotor. If the rotor is stuck in place, use a light duty puller to remove it. Clean the hub and surrounding surfaces with a damp cloth to remove any corrosion or debris.

5

Place the new rotor into position on the hub and put the retainers back into place. Replace the caliper and brake line to their original position and then secure the two mounting bolts with a torque wrench.

6

Install the wheel assembly and tire, and then repeat the process for each additional rotor. When you're done, lower the vehicle, tighten the lug nuts with a torque wrench, and then test drive your Dodge Durango to make sure that the brakes are working properly.