How to Replace the Rotor in a Toyota Tacoma
If your Toyota Tacoma seems to be shaking and shuddering to a halt, chances are it's time to replace the rotors. Rotors don't need t...
If your Toyota Tacoma seems to be shaking and shuddering to a halt, chances are it's time to replace the rotors. Rotors don't need to be replaced often, but if they get worn down or warped from hard braking and can't be resurfaced, then they must be replaced. Luckily, the installation is simple and you can do it in your own garage.
Instructions
- 1
Raise your Tacoma using jacks and jack stands. Block the wheels. Remove the first tire and wheel assembly.
2Remove the caliper mounting bolts. Slide the caliper off of the old rotor being careful not to disconnect the brake line. Hang the caliper and attached brake line from the undercarriage of the vehicle using mechanic's wire.
3Pull off the anti-squeal spring (if equipped) and then remove the brake pads. Now you can remove the old rotor and set it aside. Clean the area around the hub with a damp cloth to remove corrosion and debris.
4Install the new rotor into the hub. Replace the brake pads, anti-squeal spring, caliper and mounting bolts with a torque wrench or an air ratchet with an appropriate adapter.
5Make sure that the caliper boot isn't wedged before you replace the wheel assembly and tire. Repeat this process for each additional rotor.
6Lower your Toyota, tighten and torque the lug nuts and then pump the brake until you get a firm pedal. Be sure to road test your Tundra to make sure the installation was successful.