How to Remove an Anti-Lock Brake Sensor

Removing an ABS sensor is a fairly simple procedure. The sensors are located at each wheel hub or at the rear two wheel hubs (for two wheel ABS set-up). Check the service manual for any specific cautions for removing the sensor.

Instructions

ABS removal procedure

1

Use wire cutters to cut the sensor lead just above the sensor. This will keep from accidentally shorting the sensor wire and causing damage to the control module.

2

The speed sensor is located in its own housing which is usually attached near the wheel hub by a screw. Use a screw driver to unscrew the ABS housing. For mounts with a set screw for adjusting the air gap in the sensor, unscrew the set screw and remove.

3

The sensor housing is mounted with a lock ring. Use the appropriate open end box end wrench to loosen and remove the lock ring. The sensor can now be removed with the housing.